What to do if the weighing machine fails and how to maintain it
If you suddenly stop working one day while using the weighing machine, don't panic and calm down. Today, the editor of Guangdong kenweigh will share with you what to do if the weighing machine fails and how to maintain it. After the weighing machine has a problem, we must first troubleshoot the problem. Before checking the failure, confirm the following items: 1. Whether the correct operation is carried out according to the manual. 2. Whether there is poor contact in the wiring part. 3. Whether there is any broken or disconnected wire or wiring. 4. Whether the screws and parts are falling off or loose. 5. Whether a part or parts of the equipment is burnt, abnormally heated, deformed, etc. 6. Whether there is rust or dirt that can cause obstacles. The general weighing machine will not run out of these problems, as long as we find out the corresponding problems and solve them. So how do we maintain the weighing machine in daily life? Maintenance of the weighing machine The weighing machine is designed for powdery and poorly fluid materials. It adopts a floor-standing structure, small structure and easy installation. It has the characteristics of high weighing accuracy, simple and convenient installation and operation, strong reliability, and complete functions. It can be widely used in flour, feed, bran, metallurgy, medicine, petrochemicals, non-metallic minerals, fine chemicals, inorganic salts, Industry of non-sticky bulk powdery materials such as rubber and plastics, leather, fertilizers, etc. For this kind of high-precision electronic products, we must also do a good job of maintaining it. If you are not sure what to do, we will continue to look down. Please check the following before the weighing machine runs: 1. Whether there are any contact parts to confirm that the front and rear conveyor belts are not in contact. 2. Set the parameters to confirm whether the standard value, upper limit and lower limit are set correctly. 3. The measurement accuracy has been conveyed more than 10 times from the auxiliary conveyor for the same measurement product, and it is confirmed whether the fluctuation is large. 4. Only the main product is sent for the confirmation of the detection range, and then the test strip is sent on the main product (defective product is sent when there is no test strip), and it is confirmed that the test is not tested or tested. 5. The removal action confirms the correct removal of normal products, overweight products, and underweight products. Clean up after using the weighing machine: 1. Clean up the garbage around the scale. 2. Clean the dirt of the entire equipment. Perform the following inspections once a month: 1. Remove the conveyor belt and confirm whether the end face is cracked. 2. Confirm that the motor, roller, and conveyor belt are in the running state of the conveyor belt without abnormal noise and the conveyor belt has no deviation.
weigher linear weigher, as the name suggests, find extensive use in multihead weigher packing machine institutions. Since linear weigher has become much dependent on technology in today's world, there is wide use of such weigher.
Exceed customers' expectations in the procedures of manufacturing weigher.
Guangdong Kenwei Intellectualized Machinery Co.,LTD. incorporates average length of the workweek, average growth in number of small businesses, startup per capita, average of growth of business revenues, five-year business survival rate, industry variety, entrepreneurship index and how digital a state is.
multihead weigher packing machine weigher are primarily used for linear weigher.