What to do if there is a problem with the dynamic scale motor

Because the quality of the dynamic scale provided by domestic enterprises has been greatly improved than in the past, so when it is used, its stability is very good, and basically there will be no problems for a long time. However, there is absolutely no equipment in this world that will never fail, so when using an electronic dynamic scale, it will fail after a long time, and a large part of the reason is because of the motor. So if there is a problem with the motor of the equipment, how should we adjust it? In most cases, if there is a problem with the motor of the electronic dynamic scale, it is basically because of a problem with the insulation, which causes its internal circuit to be affected. There are two main problems with insulation, one is damp, which causes its insulation to decrease, and the other is aging. The former is very simple to solve. As long as the dryer is used for heating and the moisture in it evaporates, the insulation can be restored to use. At this time, the fault is basically eliminated. However, because there are not many opportunities for exposure to moisture in the use environment of electronic dynamic scales, the possibility of moisture is not large, and in most cases the insulation is still aging. There is no good solution to this problem, and you can only choose to replace the new insulation. However, in this process, there is one thing that needs everyone to pay attention to, that is, in the process of replacement, insulation paint must be dripped on the new product joints, so that complete insulation can be achieved. At the same time, after the replacement is completed, the equipment needs to run for eight hours. If there is no problem with the dynamic scale during this process, it means that it has been replaced.