What problems should be paid attention to when installing the checkweigher

After the enterprise purchases the checkweigher, it must install the checkweigher. What problems should be paid attention to when installing the checkweigher? Let's take a look at the problems that need to be paid attention to during the installation of the checkweigher. installation needs to pay attention to issues 1: Before training and installation, the supplier of the checkweigher machine should provide operator training at the production site. After the operators are fully trained and qualified, they can have a deep understanding of the specific checkweigher system. Cooperate with the installation, and ensure fast, efficient and safe daily operation and maintenance, so that the checkweigher can obtain a long service life. installation needs to pay attention to issues 2: installation attention points Since the checkweigher is supplied as an independent single device, its installation requirements are relatively simple, you can refer to the following points for installation: 1) Use a forklift to transport the checkweigher machine Make sure that the fork does not damage the load cell. 2) As an integral part of the packaging production line, the checkweigher is usually integrated into the same production line with other equipment, such as packaging machines, metal detectors, X-ray inspection devices, visual inspection devices, inkjet printers, labeling machines, Rejection device, etc. Therefore, it is necessary to consider placing them in a certain logical order. 3) The location where the checkweigher is installed should be selected in an area that will not be directly or indirectly exposed to vibration and mechanical shock. 4) The location of the checkweigher should be selected in an area where the air flow velocity is as low as possible, and a windshield can be installed if necessary. 5) The checkweigher must be installed on a firm platform on a flat ground, and the checkweigher must be firmly fixed on the ground with bolts to ensure that it does not move, twist or bend during use. 6) The front and rear connection points of the checkweigher machine equipment are the input section and the output section, which are close to each other but leave a gap. The checkweigher cannot have any contact with these points, and should be completely independent. 7) The checkweigher needs to leave space on the belt or chain drive side to clean and replace the conveyor. It is also necessary to leave space on the opposite side for installation, commissioning and inspection for calibration and cleaning. 8) The checkweigher should not be installed near a source of strong electromagnetic interference. 9) If the checkweigher is installed in an explosive environment, it should be ensured that all components in the checkweigher structure meet the requirements of special protection devices for industrial explosion-proof hazardous area classification. 10) All metal protective plates and parts in contact with the checkweigher should be reliably grounded, and the power plug should be properly grounded to ensure the personal safety of the operator. 11) When the checkweigher is moved and then used again, the zero setting operation must be performed before the product checkweighing can be performed. The checkweigher installation needs to pay attention to the problem 3: check after installation After the installation, the checkweigher should be started and the following checks should be made: 1) the conveyor belt runs smoothly; 2) the conveyor belt is centered; 3) the input section and output section Conveyor belt has no contact; 4) Conveyor belt speed accords with the displayed value; 5) The rejection device operates correctly; 6) The photoelectric switch operates correctly; 7) There is no vibration on the load cell. What I shared above is about what issues should be paid attention to when installing the checkweigher. I hope it will be helpful to everyone.

Guangdong Kenwei Intellectualized Machinery Co.,LTD. is dedicated to servicing our customers with a wide array of high-quality service and products.

Guangdong Kenwei Intellectualized Machinery Co.,LTD.’s mission is to be the leading global innovator, developer and provider of weigher linear weigher products, systems, and services.

In order to obtain the most suitable for your multihead weigher packing machine, you need to contact qualified suppliers which can produce super quality to your specifications and offer a friendly price.