What are the common faults and solutions of automatic weighing and labeling machines?

What are the common faults and solutions of automatic weighing and labeling machines? Today, Zhongshan Kenwei Company will share with you, I hope you can play some role after reading it. What are the common faults and solutions of automatic weighing and labeling machines? The first fault I share with you today is that the labeling position is unstable. What is the cause of this problem? How are we going to solve it? Usually, the reason for this failure is that the belt pressing device may not be pressed tightly, resulting in the loosening of the label and the inaccurate detection of the electric eye. If this is the reason, we only need to compress the belt pressing device of the automatic weighing and labeling machine. The traction mechanism slips or is not pressed tightly, so that the bottom paper cannot be taken away smoothly, resulting in different lengths of labeling, which is also a cause of unstable labeling position. How can we solve the unstable labeling position caused by this reason? Since the traction mechanism is slipping or not being pressed, we can naturally adjust the traction mechanism to a normal state. The mismatch between the labeling speed and the conveying speed and the inappropriate slope of the labeling brush at the peeling plate are also the reasons for the unstable labeling position of the automatic weighing labeling machine. The solution is also very simple. For the former, we only need to adjust the labeling speed and conveying speed to an appropriate level. The latter can make the label stick to the brush when the label is sent out, so that the angle of the label is consistent. What are the common faults and solutions of automatic weighing and labeling machines? Let's take a look at the labeling machine. What should I do if the quality of the labeling machine is not good, and there are bubbles or wrinkles? There are several reasons for this phenomenon, they are: 1. It is possible that the overlaying wheel is not parallel to the surface to be veneered, and the overlaying wheel can be adjusted; 2. The labeling speed, the conveying speed and the labeling speed do not match, most of which are out of the label If the speed is too fast, re-adjust the labeling speed or conveying speed; 3. The label strength is not enough, and it is easy to wrinkle in the process of labeling or covering the label; 4. The product to be attached is dusty or unqualified or the label viscosity is not enough, wipe the product clean or change products and labels. In fact, when we use the automatic weighing and labeling machine, we will not have any major problems. Usually, there are some small problems caused by improper operation. We only need to know the corresponding method and then solve it.