Small cleaning method and maintenance of weight sorting machine

1. Cleaning the conveyor belt of the weight sorting machine 1. The conveyor belt part that can be easily loaded and unloaded can be cleaned with warm water. The warm water of about 45 ℃ is cleaned once a week, and the conveyor belt is soaked in boiling water for about 5 minutes. 2. It can also be soaked in an aqueous solution of hypochlorous acid (200ppm) for 2 minutes, and then washed with clean water. No matter which of the above two methods, please drain the cleaned conveyor belt thoroughly before installing it on the conveyor belt. If it is installed on a conveyor belt without adequately draining the water, mildew will occur. In addition: After using the cleaning solution such as neutral detergent or hypochlorous acid aqueous solution, please wash it thoroughly with clean water. If it is used with the cleaning solution remaining, it may cause early deterioration of the belt and affect the use of the equipment. . 2. Cleaning of the main body of the weight sorting machine 1. The power supply must be cut off to prevent the risk of electric shock, and then the weight detection machine can be cleaned. 2. For cleaning tools, please use a cloth moistened with water or neutral detergent for cleaning. 3. Do not use organic solvents such as thinners and benzene - to prevent corrosion to objects and bodies, affecting use. 4. Do not use metal brushes to prevent scratches on objects and the body. 3. Tissue maintenance for weight detection 1. When the pollution caused by contact and fingerprints cannot be completely removed with neutral detergent and soap, it can be wiped with a sponge or cloth containing organic solvents (alcohol, gasoline, acetone, etc.). 2. If the rust caused by the adhesion of cleaning agents cannot be removed with neutral detergents, please use cleaning agents. 3. Rust caused by iron powder or salt can be easily removed by scrubbing with a sponge or cloth containing neutral detergent or soapy water.