Manual Baler

Zhongshan Baler | Manual Baler | How can Kenwei Packaging adjust the Baler? 1. Adjust the width of the belt and the joint when the width of the belt is uneven or when the belt of another width is replaced, it is necessary to adjust the left and right belt insertion slots. If the slot is too narrow, the insertion of the belt is difficult; There will be misalignment. Generally, the width of the slot should be about 0.5-1 mm wider than the width of the belt. 2. Adjusting the temperature of the ironing head of the baler The temperature of the ironing head has a great influence on the quality of the belt discussion. In order to make the polypropylene straps stick firmly, the knob is usually placed in the 3-5 position. Whether the temperature of the ironing head is suitable can reflect the bonding environment outside the ironing head. If there are red traces on the outside of the ironing head, the temperature is too high; if the outside of the ironing head is moist, the temperature is not enough. 3. Adjust the tying and tightness of the bundles of the baler to close the table top, and loosen the hexagon socket set screws under the big luomu A by hand. The clockwise direction is tight, and the opposite is loose. After the binding force is moderate, tighten the hexagon socket set screw. 4. Feeding belt length adjustment The length of the feeding belt is determined by the feeding belt length adjuster on the front panel. If the belt is too short, it is easy to tie the hand. At this time, the baler can use the hand to grasp the head of the belt and pull the belt out along the direction of the belt. However, it is necessary to readjust the length of the conveyor belt to ensure the abnormal operation of the downstream binding. If the strap is too long, it is not easy to aim at the position, and the strap of the baler and Panasonic is easy to wrap together to form the strap to prevent or break.