Detailed description of the structure of automatic batching equipment in weightlessness scale

The structure of the automatic batching equipment in the weightless scale includes a support point platform, a vertical mixer and a silo. The support point platform is a cylindrical hollow structure. The inner cavity of the support point platform is connected to one end of the support frame rod. The other end is fixedly connected with the outer wall of the ring frame. The ring frame is sleeved on the vertical mixer. A concave groove is set up under the inner wall of the vertical mixer. The lower part vertically shuttles through the upper inner hole and circular plate of the support point platform and widens in the inner wall of the vertical mixer. The silo is widened to the support point. A section of Taiwan Taichung is set up to match the slide bar and has a symmetry throughout. The two small round holes in the two small round holes are connected to the sliding rod. The upper cut of the sliding rod is set with a tapered hole, and the inner walls of the two sides of the sliding rod are sleeved with fixed sleeves. The two sides are connected with the inner cavity of the supporting point table through the connecting block, and the similar ends of the two sliding rods are connected according to the same ring ring. The inner hole of the ring-shaped ring of the weightlessness scale touches the outer side of the rack, and the rack is fixedly sleeved on the drive shaft 1. The upper part of the drive shaft 1 is rotatably connected with the inner top wall of the supporting point platform, and the drive shaft 1 The bottom of the bevel gear is connected with bevel gear one, the bevel gear one is connected with bevel gear two, the bevel gear two is connected with the output end of the motor, the base of the motor is connected with the inner cavity of the supporting point table, the two bevel gears are combined with bevel gear three, The lower part of the bevel gear three is fixedly connected with the upper end of the drive shaft two, the lower part of the drive shaft two shuttles on the circular plate and is rotatably connected with the circular plate, and the drive shaft two is located on the vertical fixed section of the inner wall of the vertical mixer. There is a cutter head, and the outer wall of the circular plate is fixedly connected to the inner cavity of the supporting point table. There are four supporting frame rods, and the four supporting frame rods are distributed in an isometric ring shape in the middle. The inner hole of the ring frame is fixedly connected with several protrusions, and the middle of the several protrusions is ring-shaped. The surface of the vertical mixer is provided with slots corresponding to the protrusions. This automatic batching equipment used in weightless scales is simple in structure. According to the composition structure of adding bevel gear 1, bevel gear 2 and bevel gear three, the motor drives the bevel gear two to rotate, and the bevel gear two will each be the same as the bevel gear two and the bevel gear three. To replace the toothing, the rack indirectly pushes the slide bar to move repeatedly, so that the raw material is in the middle of the two silos, and the circulation system falls from the tapered hole on the slide bar to the vertical mixer. In addition, the second bevel gear pushes the second drive shaft. The upper cutter head rotates in the vertical mixer to mix and mix the raw materials, the seasoning is high precision, the mixing efficiency is high, and it has strong versatility.