Correct assembly and maintenance method of control box in weightlessness weighing

The control box in the weightless scale is more critical in installation. It should be installed on the foundation without the influence of switching power supply, or where the smoke and dust are relatively small, and it is convenient to observe the whole process in the work. The more critical It should be installed in the operating room, and has a relatively good and reliable connection address. 1. The control panel of the system software in the weightless weighing should be installed in the electrical cabinet, and the electrical cabinet and the on-site wiring, and the cable setting must contain cable trenches, cable trays or cable trays. In the safety protection tube of the cable, the cable of the driving force and the cable of the data signal must be separated and laid. 2. According to the relevant engineering drawings of all system software of the weightless scale, install and set it to ensure the good connection of the driving force line and the power line, and conduct a detailed inspection of it. 3. Although the electrical cabinet in the weightlessness scale is eliminated from the dusty natural environment, it must be removed on time, and the smoke and dust in the components of the electrical equipment must be cleaned to ensure that the application of the electrical components can be more secure. In the case of the components of electrical equipment or related safety incidents, it must be done by professional and technical personnel. 4. If the weightlessness scale does not need to be applied to the power switch of the soft starter, then the power switch of the electrical equipment can be used to control the shutdown and start of the motor. The application of the vibrating feeder is the same. After the electrical equipment is turned off , All dashboards immediately stop working. 5. The gearbox in the weightless scale should be dismantled and replaced on time. In the case of changing the oil, be sure to ensure the quality and cleaning of the oil. If there is any residue, it will cause poor performance to the machinery and equipment. harm. 6. When the weightlessness scale is in operation, there will be alarm conditions and conditions. At this moment, it is necessary to carry out a purposeful inspection to eliminate common faults. If the data signal cable or the driving force cable in the weightless scale is laid in parallel, then a certain distance should be ensured between each other to ensure that they are not easy to cause harm before, and the distance between the two should be Maintaining above and below 300mm is a key specification to ensure the normal application of all machinery and equipment.