How to clean and maintain the conveyor belt of the needle inspection machine

Needle detectors and needle detectors often require maintenance during daily use, especially the needle detector conveyor belt. Otherwise, the pollutants or metal impurities remaining on the conveyor belt during use will have a great impact on the detection accuracy. So, how to clean and maintain the conveyor belt of the needle inspection machine? Kenwei Technology will share with you the cleaning methods and precautions of the conveyor belt of the needle inspection machine: 1. Cleaning tools: find a clean towel, wet it with water and wring it dry until the water cannot be squeezed out. 2. Clean the surface of the conveyor belt: Before cleaning, the sensitivity of the needle detector should be adjusted to the lowest level, so as not to affect the subsequent cleaning work due to excessive sensitivity. Then straighten the towel and press it properly on the surface of the conveyor belt, start the needle inspection machine, and make the machine run for more than five times (the purpose is to clean the contamination on the surface of the conveyor belt, the method can be applied flexibly), then wash the towel and twist it. Dry, repeat this step again to wipe the conveyor belt until there is no obvious contamination on the surface of the conveyor belt; 3. Cleaning the back of the conveyor belt: Many people ignore the back during the cleaning process, but cleaning the back is also very important, and then wash the towel. Clean and wring it out, pass the towel through the bottom of the conveyor belt from the lower part of the machine, straighten the towel, and draw the towel to the front of the conveyor table, hold the towel at both ends, and start the machine to run the machine for several weeks. Since the bottom of the conveyor belt is the dirtiest place, it needs to be wiped several times. After every few weeks of operation, remove the towel and wash it again and repeat the above steps. 4. How to judge the cleaning effect: After the conveyor belt of the needle detector goes through the above two cleaning steps, adjust the sensitivity to level 8 or the highest sensitivity, start the machine, and let the machine run, if the machine runs smoothly and the probe metal position display light is off At this time, put clothes without any metal impurities at this time, and the clothes can pass through the needle detector channel smoothly, that is, the conveyor belt is cleaned successfully! The cleaning of the needle detector conveyor belt is not very complicated work, but it needs to be diligent in cleaning and maintenance. In this way, the detection accuracy of the needle detector and the service life of the equipment can be better guaranteed. At present, Kenwei Technology has a variety of high-quality needle detectors and needle detector equipment, which can meet the needs of needle detection in different fields!