Common problems of automatic vacuum packaging machine

With the continuous development of society, the use of full-automatic vacuum packaging machines has basically spread to all industries. From clothing, food and housing to the development of industry and peasant industry, it has begun to be inseparable from its appearance, but as long as it is a machine, there will be various problems. Therefore, today I will work with you to analyze the common problems of automatic vacuum packaging machines and their solutions. First of all, the vacuum degree is not enough or there is no vacuum degree: first, it may be that the bag leaked and a new bag needs to be replaced. Secondly, when vacuum is needed, there may be no vacuum in the heat sealing air chamber, so maintenance should be avoided. Third, the seal or magnetic cover on the 1DT core seal may also leak and can only be repaired or replaced. Secondly, the chance of vacuum packaging has insufficient sealing strength: first, let's see if the temperature-time adjustment is too low or too short. If so, readjust. Secondly, whether the vacuum time adjustment is too short, the solution is to adjust it to less than or equal-0. 08Mpa; If neither of the above is true, it is necessary to check whether the Heat Sealing air chamber is broken. If this is the case, it will be replaced. Third, the seal is uneven or dissolved: This is mainly due to the problem of temperature and time, and the solution is to readjust it; Or 2sj cannot work normally, the solution is to readjust, repair or replace; If found heat sealing delay is too long should be promptly cut off the power supply. Maintenance is very important for fully automatic vacuum packaging machines.